How to replace custom parameters to multiple vehicles

Applies To

  • MyGeotab
  • Custom Parameters


To add a custom parameter to multiple vehicles, use the following steps:

  1. Click on the Vehicles tab
  2. Select the check mark in the top right corner of the page
  3. Choose Select Individual 
  4. Select each vehicle you would like to add the parameter to, then press Edit Selected Devices at the top.
  5. Under the Custom Parameters tab, click Replace With
  6. Paste the desired custom parameter in the text box, and click Add new parameter
  7. Click Save

Additional Notes

This will replace any custom parameters currently enabled. It is recommended to know what custom parameters are enabled on the devices to be edited first, and if still needed, make sure to add such parameters as well while bulk editing these devices.