Avatar

IOX-OUTPUT

0

Hi all,

     Please guide me.
     How to install the IOX-OUTPUT on the door of Toyota hilux vigo for control lock and unlock ?

Anusak

Please sign in to leave a comment.

3 comments

0
Avatar

Hi Anusak,

 

Thanks for contacting Geotab Support.

We have a very good document about IOX-OUTPUT, which you can find the spec and installation instruction in it. Please refer to the below link:

https://docs.google.com/document/d/1luy6izEwEgqjevr4eEpPGCeRhzV-836UG-El56PX_xs/edit#heading=h.rt8paajizqcx

Please let us know if you have any questions or concerns. 

 

Best Regards,

Wentao Xu

Technical Services Engineer

 

 

 

Wentao Xu 0 votes
0
Avatar
Hi Wentao Xu
 
Good afternoon.
 
Remote Locking of Doors using IOX-OUTPUT
 
Attached are pictures of our Toyota van.
 
We have gone through the guide of IOX-OUTPUT.
 
However, we are still not sure where to connect the other end of the cable to which part of the van.
 
Hope you are able to guide us.
 
Thank you.









Anusak 0 votes
0
Avatar

Hi Anusak,

Good morning!

You would need to set up a relay, from the wires where the switched loads is designed to control the lock and unlock of the vehicle. Unfortunately we don't have a Toyota hilux vigo van here, and we do not have the insight into how the wiring diagram of the vehicle, so please check the proprietary wiring of the vehicle and find out where to put the relay for your application. 

Please refer to the following diagram and table for some references.

 

 

Best Regards,

Wentao Xu

Technical Services Engineer

Wentao Xu 0 votes