Avatar

How to simulate ignition with 2 wire install

0

I am using the two wire install method. My power source is a 12 volt battery that remains constant. There isn't ever a fluctuation in voltage, so the device never powers on, as with a typical two install in a vehicle. How can I simulate the ignition always on with a custom parameter?

Kameron Kelley

Please sign in to leave a comment.

1 comment

0
Avatar

Kameron,

What kind of equipment/vehicle is this device installed in? 

My initial suggestion would be to use a GO7 with a 3 wire harness, the 3 wire harness has a third wire for ignition detect so you could connect that to a circuit that goes to 12v when the equipment/vehicle is in use.

Mauricio Muniz 0 votes